Precautions for the use of NTC thermal protectors

　　1. When the lead wire is used for bending, it should be bent from the part that is more than 6 mm away from the root; when bending, the root and lead should not be damaged, and the lead should not be forcibly pulled, pressed or twisted.

　　2. When the thermal fuse is fixed by screws, riveting or terminals, it should be able to prevent mechanical creep and the occurrence of poor contact.

　　3. The connecting parts should be able to work reliably within the working range of electrical products without displacement due to vibration and impact.

　　4. During the lead welding operation, the heating humidity should be limited to a minimum. Be careful not to add high temperature to the thermal fuse-link; do not forcibly pull, press, or twist the thermal fuse-link and lead; After welding, it should be cooled immediately for more than 30 seconds.

　　5. The thermal link can only be used under the conditions of the specified rated voltage, current and specified temperature, paying particular attention to the maximum continuous temperature that the thermal link can withstand.

Read recommendations:

NTC sensor for monitoring temperature in gas field

NTC chip bonding process blue film packaging NTC thermistor.Moving object detection module

10.525G 18m distance HW-RB10 millimeter wave radar sensor module

PIR Lens 8605-2C

HW8004 Night light microwave sensor module，PIR sensor module