Installation and use instructions of ntc temperature control switch.Radar Microwave Induction Sensor Switch

　　1. Grounding method: connect to the grounding metal parts of the equipment through the metal cover of the thermostat.

　　2. The temperature control switch should work in a general indoor environment where the relative humidity of the air is not more than 90%, and there is no corrosive gas, flammable gas and conductive dust.

　　3. When the temperature control switch adopts contact temperature sensing, the cover should be close to the heating part of the controlled appliance, and the temperature sensing surface of the cover should be coated with thermal conductive silicone grease or other thermal conductive medium with similar performance.

　　4. When the thermostat senses temperature through contact with liquid or steam, it is recommended to use a product with a stainless steel cover, and there should be reliable leak-proof measures to prevent liquid from seeping into the insulating parts of the thermostat.

　　5. Do not collapse or deform the top of the cover, so as not to change the operating temperature or affect other performances.

　　6. Do not allow liquid to penetrate into the inside of the thermostat! The casing must be protected from excessive force to prevent cracks; the casing should be kept clean to prevent contamination by conductive substances to avoid short-circuit breakdown due to reduced insulation performance.

　　7. Do not bend the terminal during use, otherwise the reliability of the electrical connection will be affected.

　　8. The power supply shall not exceed the declared voltage and current, the load power and type shall meet the declared requirements, and the ambient temperature shall not exceed the declared maximum allowable temperature.

Read recommendations:

What is the NTC function of the battery

NTC temperature sensor for curlers.Human Body Infrared Temperature Sensor

PIR Lens 8731-1

PND103F3950FTP706 NTC Thermistor 10K 1% 3950

PIR Lens 8120-4