Usage of NTC shockproof floodlights.white metal garage shelving

　　Based on the on-site environment and lighting needs, after determining the appropriate installation location and method, prepare according to the length of the ballast to the 220V power supply contact φ 12-14mm three core cable.

　　Unscrew the fixing screws of the rear cover of the ballast, open the rear cover, and then loosen the compression nut of the ballast cable inlet. Thread one end of the cable through the compression nut and introduce it to the input wiring base of the control circuit board. Connect and fix the L, N, and grounding wires of the cable to the corresponding wiring base. Then tighten the cable compression nut and tighten the rear cover of the ballast with screws.

　　At the selected installation location, use the φ Install and fix the lamp and ballast with 10mm expansion bolts.

　　When replacing a light bulb, first loosen the three butterfly nuts in the middle of the lamp head, then forcefully pull the tail of the lamp head upwards to open the lamp head, unscrew the damaged bulb and replace it with a new one, and finally restore the lamp head in the opposite order.

　　Warning: When disassembling, repairing lamps, and replacing bulbs, the power must be cut off first.

Read recommendations:

MF52 thermistor -resistant parameter.PIR Motion Sensor Module

Classification of thermistor materials

Φ6.5mm size with metal case

PND103F3950FTR305 NTC Thermistor

HW-M10-2 microwave sensor module